Power


New 90A digital PoL modules address growing challenge of powering advanced ICs

CUI has released its highest current digital POL family to date. Designed specifically to address the rapidly-rising power requirements of today’s most advanced integrated circuits, the NDM3Z-90 is a non-isolated module outputting 90A in u

CUI | 17-03-2015

Secondary-side synchronous rectifiers significantly reduce power dissipation

Diodes' APR3415 and APR34330 secondary-side synchronous rectifiers are now available from Digi-Key. They combine a N-MOSFET and optimized driver circuit for DCM synchronous rectification (SR) power supplies. They significantly reduce the

Digikey | 16-03-2015

First 80V half-bridge GaN FET module

Introduced as the industry’s first, an 80V, 10A integrated gallium nitride (GaN) field-effect transistor (FET) power-stage prototype has been unveiled by Texas Instruments (TI). The device consists of a high-frequency driver and two GaN FE

Texas Instruments | 16-03-2015

New 90A digital point-of-load DC-DC converter for high-demand networking equipment

Ericsson has launched a new two-phase 90A 3E digital point-of-load (POL) DC-DC power module that offers compensation-free performance and the ability to easily connect modules in parallel to provide up to 360A to advanced network-processors

Ericsson Power Modules | 16-03-2015

Low-power high-performance 5Gbps signal re-drivers for the USB 3.0 applications

Pericom's PI2EQX502T low-power high-performance 5Gbps signal ReDrivers are now available from Mouser. The devices are designed specifically for the USB 3.0 protocol and provide programmable equalization and de-emphasis to optimize perfo

Mouser Electronics | 16-03-2015

Isolated 1W DC-DC converters in low-profile surface-mount packages

Murata Power Solutions NXE1 1W isolated DC-DC converters are now available from Mouser. The low-profile surface-mount devices offer increased product reliability and repeatability of performance in a halogen free iLGA inspectable packag

Mouser Electronics | 13-03-2015

Simple solution to linear driving of LED chains with two pin packages

Mouser now stocks Diode Inc's AL5809 constant current LED drivers. They deliver a simple solution to linear driving of LED chains with two pin packages. The device features high temperature stability and current accuracy regulated over

Mouser Electronics | 13-03-2015

Fully-regulated quarter-brick DC-DC bus converters maximize efficiency

Housed in an industry standard 5-pin package, CUI's Novum NQB-N DC-DC converters are now available from Mouser. The fully-regulated converters use power-optimizing firmware to maximize efficiency and provide peak performance. Typical ef

Mouser Electronics | 13-03-2015

High-voltage regulator transistor cuts footprint to deliver 5V to microcontrollers

Diodes Incorporated has introduced the ZXTR2105F, a new regulator that monolithically integrates a transistor, Zener diode and resistor to provide a 5V 15mA output from inputs up to 60V. Offered in a small SOT-23 package, the device transis

Diodes Inc | 13-03-2015

First zero standby power PSR for high-power AC/DC supplies

Introduced as the industry’s first, a new zero standby power controller chipset with the lowest standby power consumption for AC/DC fly-back power supplies up to 75W, the UCC28730 has been developed by Texas Instruments (TI). Taking powe

Texas Instruments | 12-03-2015

Enhanced peak current mode controller capable of controlling HPF LED drivers

For applications such as single-stage LED drivers with high power factor (HPF) up to 75W and two-stage LED drivers up to 150W, the STMicroelectronics HVLED001 offline LED controller is now stocked by Mouser. The enhanced peak current-m

Mouser Electronics | 12-03-2015

Digitally-controlled 300W eighth bricks offer improved dynamic response

TDK has introduced the iEH series of 300W 1/8th brick DC-DC converters. Utilising digital non-linear adaptive control, they offer improved dynamic response, better system stability and increased reliability due to a reduced component cou

TDK | 12-03-2015

Adjustable power limiters protect systems against over-current faults and more

Designed to guard systems against over-current faults in addition to positive over-voltage and reverse-voltage faults, Maxim's MAX14721, MAX14722, and MAX14723 high-accuracy adjustable power limiters are now available from Mouser stock.

Mouser Electronics | 12-03-2015

Power supply can be quickly customised with no NRE costs

Powerstax has announced a configurable power supply that can be built to meet exact custom requirements but without the lengthy lead times and non-recurring engineering (NRE) costs generally associated with a customised solution. Key mar

Powerstax | 12-03-2015

Articles